Bruce One Step Acrylic Finish

Bruce One Step No-Buff Acrylic for Wax Finish Floors

This is a great solution if you're tired of waxing and stripping older wax finish floors.

Dries to a lustrous shine.

DO NOT use on urethane finish floors.

 

Bruce One Step Directions:

1. Sweep or vacuum you floor
2. Ventilate room to be cleaned
3. Important: You must clean floor with Bruce Clean ‘n’ Strip to remove wax build-up. If not, dull finish can occur.
4. Pour a small amount of product on the floor
5. Apply thin coat over 3x3 area with a clean, dry applicator and finish with smooth strokes in one direction. Continue process until entire areas is covered.
6. Allow to dry for approximately one hour. New or worn floors may require a second coat. DO NOT BUFF as Bruce One Step dries to a lustrous shine.
7. After use, wash applicator in a detergent solution and rinse with clean water.
8. Store at room temperature

 

Helpful Hints:

DO NOT wash wood with water or detergent.

DO NOT use on asphalt, rubber, tile or floors sealed with urethane coating’s

Recommended application every 3 months